Hello
I need to apply 4 inclined surfaces per scanning element on a drill grid. ( similar to a thread with 4 gears with a inclination of 50 but only 4 mm deep) the whole thing only works with G141, Unfortunately the machine backs out after the tool is engaged with G0 ‘tolerance margin C axis too big’
I have already tried the feed limitation (F2) but it only works on G1.
All G0 to G1 with large feed is therefore useless as the feed limitation (F2) interferes.
Do you know any other possibility to limit the rapid feed apart from choking the rapid feed Poti to 40%?
Regards eckitsch.