Hello!
I have the following little problem: on our Spinner VC360 with Shopmill I wrote a little ISO program for demonstration purposes to show the usage of calculation parameter and contingent jumps (it works without problems) unfortunately the simulation uses a raw part about X100 Y100 Z-30 which doesn’t represent my own raw part (120X30x20).
I don’t even know where it comes from because in the ISO mode I don’t have a program head like on Shopmill and the command WORKPIECE... is completely unknown to the controller. I couldn’t even find a soft key that can help me out.

I already had a look at doconweb, Siemens and other documents but without success..so I try it here now.

Hopefully someone can give me some advice how to enter the raw part into the simulation.
Many thanks in advance!