Good evening everybody
I am working on a DMC 80 with a Siemens 840S controller.
The machine has a tool magazine for 60 spaces and for the HSK 64-tapers.
How do I program that the machine prepares the next tool for the change during the operation?
As nobody knows, the tool change takes quite long!
I would appreciate any suggestions or ideas!
Kind regards
Uwe
Thread: tool preparation
Results 1 to 4 of 4
-
03-08-2010, 11:46 PM #1
- Join Date
- Feb 2010
- Posts
- 12
-
03-09-2010, 07:16 AM #2
- Join Date
- Dec 2003
- Posts
- 507
I think that the command T="XXX" is enough for the preselection of the next tool.
The tool is then supplied in the magazine.
The proper command to change it is M6.
You program it when you want to change the tool that your already prepared earlier.Gruß<br>Markus
-
03-09-2010, 11:20 AM #3
- Join Date
- Feb 2010
- Posts
- 12
Good morning
Thank you for your answer.
I will try it out later ...
I will report back to you!!!
Kind regards
Uwe
-
03-09-2010, 10:48 PM #4
- Join Date
- Feb 2010
- Posts
- 12
Hello Markus
I have tried it today exactly as you described it.
After changing the tool, I called the next tool with one single block.
It worked without any problems.
THANK YOU!!!
Reply With Quote
Posting Permissions
