Hello Meet,
In general I can’t see any mistakes!
You write about a B axis , but you position with C3.
It would be good to know what machine it is and what cycle L140 is doing.
If you position with C3, what is happening with C1 and C2?
I guess you define the milling spindle with SETMS(2) to a master spindle ( wherever it is)
So in such a case, the axial configuration would also be important!
Furthermore to know what else the machine is doing regarding error messages come up and what errors occur.
It seems that your PP is not correct. What programming system are you using?
Regards
engineer Egmont Schleich
T E C A S
Technology Assistance
www.tecas.at
Ing. Egmont Schleich<br />T E C A S - Technology Assistance<br />www.tecas.at - Kundenorientierte Zyklenpakete und Lösungen <br /><!--sizeo:3--><span style="font-size:12pt;line-height:100%"><!--/sizeo-->Was einmal erdacht, kann nicht zurückgenommen werden.<br /><!--sizec--></span><!--/sizec-->aus "Die Physiker" von Friedrich Dürrenmatt