Greetings All,
This is my first entrance to CNCzone. I am preparing to startup a Hermle 721 equipped with the Siemens 810M. I would like to find other users of the same machine, or 821, or 1000 Hermle, or other machines where the 810M is used and understood. I have schematics(721), machine/NC parameters(721), and a fair number of commissioning/programing manuals for 810M. I have a DB9-DB25 RS232 cable and would like to enter machine constants using a PC via hyperterminal.This machine was mis-represented on ebay and arrived without the x axis servomotor. I have another motor installed, but polarity connections for both power and tacho are not clear, especially with respect to machine constants. I am preparing for the worst!
Thank you for any assistance /insight.
cygnetron