1. Press soft key ”SETTING DATA”
2. Extent button soft key bar
3. Press soft key ”SE-BITS”
SD 5010 ... 00000100 device identification
SD 5011 ... xx xxx 111 9600 Baud (x ... without meaning)
With that the 1. interface is adjusted to the PG.
4. Button Recall. Return to basic display
5. Press soft key ”DATEN ON-OFF”
1. Select interface (enter”1”).
“PLC-PROG.” must be displayed in the interface assignment of the 1.interface.
6. Press soft key ”DAT. IN START”
Like that the NC of the 1. Interface gets activated.
Only when the soft key ”DAT. IN
START” is pressed twice, you will get a feedback on the NC screen. When you press it the second time you will get the input message “interface occupied”
The alarm 22 (time surveillance V.24) is switched off in this operation mode, also the interface signal ”V.24 is running”.
7. button recall. Return to the basic display
After that you can go online with Step5
There are only 10 types of people in the world: Those who understand binary, and those who don't<br />Wir haben einen exponentiellen Zuwachs an <strike>Doofen</strike> Pack im Forum