Hello,
I've got a problem...
After an operator/machine-misunderstanding :-)
I wouldike to align the tool disc at a Maho Graziano GR200CE...
Therefore I did the following:
- dial gauge attached at the chuck
- caliber clamped into collet and put in the bracket at tool position 2
- chuck turned by hand
- this ''Test composition'' placed at Z 200 und X0 (G53)
The pointer deflection there (0,01mm pitch) should be vanishingly small... about 1 scale's partial step :-)
Next I change my ''Test composition'' at slot 6 or 7, because they are subtended...
My problem: the pointer deflection is more than 0,1mm!!!
Could anybody help me, please...
Thanks a lot.
Greetings,
Kelle