[Merle]

Good day
We have bought a used CNC lathe.
The machine has a eight-digit turret of the brand lio shing "ls 120 x st"
Unfortunately we did not get any documents for it.
Can someone tell me how I have to adjust the y axis in order to set up the cutting chisel and dill.

Kind regards
merle

[Drehteileanfertigung]

Hi Merle
The type of machine and controller would be necessary to know...
Y-axis sounds like a combined machine with AGW's.

greetings Guido

[Merle]

Hello
The machine is a 510 x 1000 Fulland with fagor 8050/55t controller.
I only need to adjust the height of the tools in the turret.

e.g. when I turn my work piece plane, then a small tip always remains in the middle. So my chisel should be adjusted slightly upwards. I'm just not sure where and how I do it on the revolver.

There is a stud screw located on the side of the turret, like on each tool, and I guess that’s how I could adjust it..
I've already tried it but could not detect any alteration. I don’t know in what position the revolver should be either, because the screw is difficult to turn.

Merle