We have a 1995 Toyoda FA630 with a Fanuc 15m control. The Fanuc manual says it should be able to use G95 (feed/rev.). The toyoda manual says "G94 = feed inchs per. minute - G95 = feed" and thats it. When I try to feed with G95 it just sits there w/cycle start light lit and no motion. Any insight in this area would be apprieciated.
A.J.L.
P.S. is there any way to know what options this machine has via. the control or otherwise?
Thread: Fanuc 15m
Results 1 to 3 of 3
-
08-16-2006, 05:23 PM #1
Registered
- Join Date
- Jun 2006
- Posts
- 478
Fanuc 15m
-
08-16-2006, 08:53 PM #2
Registered
- Join Date
- Nov 2004
- Posts
- 13
Is the spindle spinning? If your trying to feed in ipr, the spindle must be turning.
-
08-17-2006, 02:48 AM #3
Registered
- Join Date
- Jun 2006
- Posts
- 478
yes it is, the machine may not even have the opp.
Reply With Quote
Posting Permissions
