Hello,
I had spindle damage at my milling cutter. I saw that the borehole where the spindle had been picked up was not clean, ca, 1/5 of the hole was not clean.
May it be concerned with the spindle damage?
Regards
Kiki
Hello,
I had spindle damage at my milling cutter. I saw that the borehole where the spindle had been picked up was not clean, ca, 1/5 of the hole was not clean.
May it be concerned with the spindle damage?
Regards
Kiki
HAAS VF7 - BJ2008<br />HAAS ST20<br />HAAS ST10 mit Stangenlader<br />HAAS Mikron VCE1000<br />EMCO 365<br /><br />www.KDC-Technik.at
Hello!
What milling cutter is it?
Do you mean the cylindrical case where you insert the spindle?
Is it integrated horizontally or vertically?
Gruß,<br />spindelservice<br />
If I interpret correctly that what you wrote, it isn’t concerned with any spindle damage.
I think a rough part was cast too large, so that it couldn’t go out completely.