Hello!
What could be reason of the fact that our spindle gets stuck after an hour with retracting 100r/min after spindle service (remounting)? Did the technician cause that?
Thanks
Greetings
Andreas
Hello!
What could be reason of the fact that our spindle gets stuck after an hour with retracting 100r/min after spindle service (remounting)? Did the technician cause that?
Thanks
Greetings
Andreas
It can have a lot of reasons
Wrong mounting of the bracket
Wrong mounting of the spindle
The spindle was badly fixed after installation
The spindle wasn’t balanced after installation
etc.
There’re a couple of reasons more.
gruß Klaus
What spindle is it?
The spindle is inside of a Deckel Maho 600W.What spindle is it?
But it’s without the 18-stepped gearing
Regards, Andreas