[MagTDK]

I hooked up my xylotex board today to my cnc machine and attempted to jog the motors using Mach 3. Unfortunately it's not working like they should. I hear some noise and can feel the motor vibrating when hitting the jog button, just no shaft movement. I even disconnected the motor from my machine to see if that was the problem, but that didn't work either. In fact, the motors are locked up like when I first power on the unit. I also tried messing around in Mach 3's motor tuning section but nothing there either.

I also followed the first video tutorial at the support page for Mach 3 incase I missed something, and have been reading the docs as well. I know this has to be some sort of configuration problem, I just don't know were to look. I'm using this xylotex kit: http://www.xylotex.com/4AxSysKit.htm

So can anyone point me in the right direction?

[Guldberg]

Sure you somehow didnt set the jog speed to ultralow or set the stepping wrong so its just sending to few steps to feel it moving?