My question is, after I post the G code made by a wizard to the main Mach 2/3 screen, how do I go back to the wizard and change say a step depth or feed rate etc. I am aware that the G code can be edited on the main page of Mach 2/3 but I would rather go back into the wizard that I just created and do the minor adjustments there then repost the code. How is the correct way to do this?
Thread: Return to wizard for change
Results 1 to 3 of 3
-
08-16-2006, 07:43 PM #1
Registered
- Join Date
- May 2006
- Posts
- 89
Return to wizard for change
Exotic Welder
-
08-16-2006, 08:34 PM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Save the settings in the wizard before you exit it. Unload the code from Mach3, and go back to the wizard. Make changes. Repost code.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
08-16-2006, 10:22 PM #3
Registered
- Join Date
- May 2006
- Posts
- 89
Simple
Hey thanks,
That sounds simple like me.....Exotic Welder
Reply With Quote
Posting Permissions
