[sml2010]

Hi

I have a 3 axis milling machine with Fanuc 10M controller.

this controller is old and i can't send very complex shape because of low memory capacity.
Does any way to make the memory bigger with add a hardware to machine to make the memory bigger with add a hardware? or is any method to use this machine for machining complex surfaces?
I send my files with RS232 Cable, it doesn't have DNC mode .

I am wait for your reply.

Thank you

[Al_The_Man]

I don't believe the 10 can be increased by parameter, without hardware, contact Memoryman here he can supply you will a add on maybe.
Al.

[tc429]

think the 10 had ram+parity rams, where the 11 used bubble, or memoryman/tulip electronics excellent ram replacement...think on the 10 you just need 6 rams, 4 parity rams and parameter change...havent messed with one in many years. note, i think maximum is still small by todays standard, better to add dripfeed if you need more than 100k characters or so...

[hangslot]

You can run the program in Tape mode, using dripfeed software.