Hi everyone!
I bought an old (1986) mill equip with a Crusader M control that I was planning on retro fitting however the control does power up but the diagnostic tests show a 'DUART failed'. Is this fatal as in it's cheaper or easier to replace the control or is it an easy fix?
Any help would be appreciated!
LaVerne
Results 1 to 3 of 3
-
08-30-2006, 01:30 AM #1
Member
- Join Date
- Jun 2003
- Posts
- 242
My New/Old Anilam Crusader M has a problem
-
08-30-2006, 04:03 AM #2
Registered
- Join Date
- Mar 2004
- Posts
- 1543
Time for a new control. Even if you solve this one, it will just go down again. Today's hobby controls are light years better than the professional controls of 20 years ago.
Karl
-
08-15-2008, 01:10 PM #3
Registered
- Join Date
- Oct 2007
- Posts
- 36
Sorry gents. The uart was a brain fart on Anilam's part. It was to be for future use. The control doesn't have it installed.
Good luck - I still use my M.
Reply With Quote
Posting Permissions
