I have a Messer MG plasma table with Navigator control. I am currently using a Hypertherm HD3070 and a HT2000. My THC has been acting up for a long time now. We use two torches and one of the THC's quit working about 2 years ago. I just switch the torches out now and have for the past two years with no issues, until now. The problem I have been having lately is the torch will move to the next pierce and either not lower at all and try to fire from the up position or it drops a little and tries to fire. I have to stop it and start it sometimes once, sometimes numerous times before it will lower to the proper height. We had someone come in from Hypertherm a couple years ago and he wanted 26 grand to try and get a new one to work with our old table and he wasn't sure about success. That's when I decided to just switch torches and go from there. I was wondering if the Sensor PHC would work with my setup, the website says it works with ANY CNC control.

Thanks,

John