Re: Leadshine Easy servo drive connection problems
I setup some Leadshine brushless drives and had the same problem. The "Pro"tuner program wouldnt connect reliably, and then sometimes it finally would. (with no indication you were connected)
Also the program doesn't show live data, its a real mess. There is a Tab when you set movement parameters, then the motor does a little dance, then the graph displays data slowly across the screen . I got the motors sort of tuned, but they did dither a bit and were a bit soft. The current limit didn't seem to have an effect and i couldn't get the motor to trip if the machine hit an overtravel.
There also seemed to be no way of reading the parameters from a programmed drive.
Try turning the motor power on and off while its suppose to be connecting (although there is no indication of whats going on.) , that seemed to make it connect. btw, i was using XP
Manufacturer of CNC routers and Viper Servo Drives
www.LarkenCNC.com and www.Viperservo.com