Anyone know of anybody that repairs 1.5kw Chinese spindles?
Anyone know of anybody that repairs 1.5kw Chinese spindles?
I guess that would depend on what's wrong with it.
But most likely, it would be far more expensive to get it repaired than to buy a new one.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
posting entered twice.
Hi
if it is the windings then buy new spindle if it is the bearings then it can be done with a few simple tools, Is yours air or water cooled, mine is air cooled and have just found out how to strip it down, also remember that the spindles use c3 clearence bearing due to the high speed that run at.
Mick