586,058 active members*
3,393 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Benchtop Machines > BF20 Real life Mach3 motor tuning

Thread: BF20 Real life Mach3 motor tuning

Results 1 to 3 of 3
  1. 12-08-2014, 11:50 PM #1
    bladehunter
    bladehunter is offline
    Join Date
    Nov 2009
    Posts
    98

    BF20 Real life Mach3 motor tuning

    Hi guys,

    I was just wondering what values BF20/G0704 owners are using for Acceleration & Velocity.

    My setup is:
    570 steppers
    KL-6050 set at 1/8 micro stepping
    48 Volt power supply
    1605 Ball screws
    (basically Hoss's reccomendations for the elctronics)

    I've got the 320 steps per mm sorted, just wondering what seems to be good values to start off with

    Cheers
    Rob
    Stoner #1
    Reply With Quote Reply With Quote
  2. 12-09-2014, 12:35 AM #2
    Kenny Duval
    Kenny Duval is offline Neuer Benutzer
    Join Date
    Jan 2013
    Posts
    630

    Re: BF20 Real life Mach3 motor tuning

    I'm using the following

    100 in/min and acceleration rate of 15 on each axis.
    Reply With Quote Reply With Quote
  3. 12-09-2014, 01:17 AM #3
    bladehunter
    bladehunter is offline
    Join Date
    Nov 2009
    Posts
    98

    Re: BF20 Real life Mach3 motor tuning

    Cheers Kenny
    Stoner #1
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. mach3 motor tuning
    By largas in forum DIY CNC Router Table Machines
    Replies: 15
    Last Post: 12-10-2014, 06:22 PM
  2. motor tuning in mach3
    By topchippy1 in forum Mach Software (ArtSoft software)
    Replies: 4
    Last Post: 06-22-2012, 10:04 PM
  3. mach3 motor tuning
    By taigfraeser in forum Taig Mills / Lathes
    Replies: 9
    Last Post: 07-03-2010, 05:51 PM
  4. Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR)
    By MDF_Markazi in forum Mach Software (ArtSoft software)
    Replies: 7
    Last Post: 04-30-2009, 08:15 AM
  5. Motor tuning under Mach3
    By BAustin in forum Charter Oak Automation Support Forum
    Replies: 3
    Last Post: 12-24-2006, 06:23 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules