[rjmorel]

Got a new to me sinker, 1996 Santec 300c with F36 controller. I need help with what all the knobs and toggles do on the machine. No manual came with machine. Heres some close ups of controller. Can anyone tell me what the symbols mean in each. I'll put what is written by some of them but I need to know what they do. Thanks, rj
what do these 4 toggle switches do?


What do the 6 yellow things do or tell me? reset and u-spark are push buttons, rest are lights I think. What do the 4 toggle switches do? on/off but don't understand what the symbols refer too.


these red knobs read :
pulse on //////// SENSITIVITY //////// current selector 0-1.5 A ////////// Discharge voltage 1-10///////// Electrode lift 1-10
pulse off //////// TIME /////// current selector 0-75 A ////////// servo speed 1-10 ///////// Duration 1-10.....toggle on/off for ram cycle lift, duration
toggle 1.5t, t////////// toggle auto, normal


Controller is very similar to this one.


Machine very similar to this one:

[rjmorel]

Got to be some one in this country that has one of these?????? Any help would be greatly appreciated. Even little bits to help me figure out the puzzle. Don't need a thesis ,just what the pics mean on the switches, I can figure out the rest. Thanks, rj