Can someone please remind me of the steps to edit parameters on a Mori NLX with a Mitsubishi control. I only remember to set the machine to MDI and press SYSTEM, then SETUP. I also don't remember if I set the key to Edit etc. Thanks
Results 1 to 3 of 3
-
11-05-2014, 05:31 PM #1
Registered
- Join Date
- Nov 2014
- Posts
- 2
Editing Paramaters Mitsubishi control on Mori NLX
-
11-05-2014, 11:32 PM #2
Member
- Join Date
- Feb 2013
- Posts
- 788
Re: Editing Paramaters Mitsubishi control on Mori NLX
While someone .here MIGHT be able to answer...you might get better answers posting in the Mori section instead of the Doosan section
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
-
12-19-2014, 06:21 PM #3
Registered
- Join Date
- Oct 2012
- Posts
- 8
Re: Editing Paramaters Mitsubishi control on Mori NLX
Press MDI
Press Setting
Press F5 "PARAM"
EXIT
go back to SETTING
move NC PARAMETER WRITE to valid
Reply With QuoteSimilar Threads
-
Mori NL1500 with Mitsubishi control lost X-axis absolute home zero. Need instruction
By teal854t in forum Mori Seiki lathesReplies: 0Last Post: 05-20-2013, 11:04 PM -
Post editing Mitsubishi VX20
By carbon carbon in forum EDM Discussion General TopicsReplies: 0Last Post: 07-19-2012, 04:50 PM -
macros and paramaters for a hitachi mill with fanuc 6mb control
By beekeeper in forum FanucReplies: 1Last Post: 08-17-2010, 04:51 PM -
PMC editing on 16m control
By whallnut in forum FanucReplies: 6Last Post: 05-07-2009, 01:14 PM -
I need Two Paramaters for 6M Control
By 6105Moss in forum FanucReplies: 6Last Post: 01-24-2006, 09:46 AM
Tags for this Thread
Posting Permissions
