Hi,
I just started working with a MultiCam 5000 table.
At work thay only use it for 2D jobb's. So they only have the Enroute 2D software.
In my private shop, I use RhinoCAM 1, and Rhino 4, When I post a 3d(3 axis) relief to a .cnc file and open it in the MultiCAM controller,
I see only a small dot/pixel on the hand controller display.
When I open the CNC file in the "Jobb editor" nothing is displayed, I even tried to cut and paste the initial g-codes from G90 etc. from a 2d .cnc file that was produced by Enroute.
Stil it would not display annything in the jobb editor.
In RhinoCam I use the MultiCam post. RhinoCam support says, there is nothing wrong with the MulitCam post, only that I may have to change to positive tooldown. (tool down = +1)
I did not dare to test it yet.
Does anybody know anything about what could be causing the empty display?
Thanx for the help!