Having the above problem, especially when I try to save a bbcd. file as a dxf. file. The program goes into a forced shutdown. I did some searching on line and got a hint this might be due to having Windows 7 rather than the Windows XP I used to run. Any ideas? Thanks
Results 1 to 8 of 8
Threaded View
-
11-21-2014, 05:36 PM #1
Registered
- Join Date
- Oct 2014
- Posts
- 6
Bobcad V25 shutting down with a "Runtime error" message
Reply With QuoteSimilar Threads
-
Hurco Hawk 30 - "Way lube oil low" error message
By NPE Ltd in forum HURCOReplies: 15Last Post: 01-07-2014, 08:06 PM -
"master encoder state error" AB ultra100 error message
By ShapeShaver in forum Servo Motors / DrivesReplies: 3Last Post: 07-31-2013, 04:09 PM -
Predator Editor not working- "Index Out of Bounds" Error Message?
By cismontguy in forum BobCad-CamReplies: 2Last Post: 02-17-2013, 02:49 PM -
"Runtime error 9 - subscript out of range" on Techno CNC interface
By zhoudfoster in forum CNC (Mill / Lathe) Control Software (NC)Replies: 4Last Post: 10-26-2009, 04:57 AM -
V2XT error message "DRIVE FAULT detected (0,z,y,x) check log"
By rfdoyle in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-08-2007, 09:35 PM
Tags for this Thread
Posting Permissions
