586,106 active members*
3,134 visitors online*
Register for free
Login

Thread: Need some expert advice

Results 1 to 2 of 2
  1. 12-04-2014, 05:31 AM #1
    nonapjoe
    nonapjoe is offline Registered
    Join Date
    Oct 2014
    Posts
    1

    Need some expert advice

    Hi everyone. New here and hope I'm posting this in the right forum. I've been cutting MDF with my router and seem to be getting these lines on every tool pass. It's almost a small step if I can describe it that way. Would anyone happen to know whats causing this? Thank you in advance for any guidance you may have. I've attached a picture of the problem.

    Kevin.
    Reply With Quote Reply With Quote
  2. 12-04-2014, 09:03 AM #2
    mcv
    mcv is offline Registered
    Join Date
    Nov 2014
    Posts
    34

    Re: Need some expert advice

    try to do finish (full depth) contour cut at the last process,
    it seems you just use stepover contour to finish
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Designing/Building my own CNC Router, need expert advice.
    By ThinkItBuildIt in forum Community Club House
    Replies: 2
    Last Post: 02-02-2014, 08:02 AM
  2. Need advice from Expert! P/N compatible Fanuc 6M and 6T
    By cjchands in forum Fanuc
    Replies: 2
    Last Post: 02-04-2009, 11:47 PM
  3. Expert advice needed Rubber grades
    By Al_The_Man in forum Mechanical Calculations/Engineering Design
    Replies: 6
    Last Post: 11-15-2008, 05:39 PM
  4. Help! I need some expert advice!
    By losgetlost in forum DIY CNC Router Table Machines
    Replies: 16
    Last Post: 08-16-2008, 07:39 AM
  5. Help - Need some expert advice
    By nosplinters in forum Benchtop Machines
    Replies: 6
    Last Post: 06-28-2007, 11:20 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules