hello all
iw just recieved my new stepper motors and after a bit of test running i can get em up to ~130rpm (400steps per rev).
These are the specs for the motor
Unipolar:
Rated Current 2.0
Phase Resistance 5.0 Ohms
Volt Phase 10V
Phase Inductance 29mH
And i was wondering if this is normal for this kinda motor or is it supposed to go faster?
My driver only does microstepping (400steps per rev) and it is set for 2.0A peak current per phase. Motor is 8wire and wired up as Parallel. Should the current be set as 2.0A or should it be more in the area of 4.0A when wired this way?
Hope you understand my scribbles
edit: Yay running much faster now after some fiddling feel free to give your thought anyhow