Hi
I have a 4 axis table that I built a number of years ago which I pulled out of moth balls. I am trying to get running again. I have a new computer and stepper motors and the break out board and stepper drivers are new
I can get the mc to run, but it cutts at 0.6 mm/s and the hot wire even when turner down creates a huge kerf
I have tried to change the steps per mm but end up with a wing that either is tooo small or one that will cut right though the end of the foam blank with the old set up it worked pefectly so now I am really confused.
If I run Mach3 the steppers seem to run at the correct speeds.
I would welcome a few suggestions.
Neville