Hi guys,
I have this Delta Tau motion controller card that has 10, 26, 34, 50 pins females IDC pins that need to be connect to motors/drive, etc.....
Problem is I could either connect it directly thru the IDC connector but it will be extremely difficult for unskilled soldering person like me.
Or
I have been told that I can get breakout board out there, but I have checked thru website like Phoenix, etc...it cost 80-90 bucks per board!!!
Yike..
Any suggestion or where to get it cheaper for 10, 26, 34, 50 pins?
Help is appreciated it.
Jeff