I'll send the file, or any help would be great. I need it to look close to the real picture attached. Thank you very much. [email protected]
I'll send the file, or any help would be great. I need it to look close to the real picture attached. Thank you very much. [email protected]
Ruled/lofted surfaces worked great. Thank you all.
I got closer, but still not real happy,lol. I don't like the dip in the middle.
Great, thank you.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
That is better than mine for sure. Mastercam x5. I would really like it to look like the wooden actual carved one in the photo. I could email you the .stl and you should be able open it with anything then.
I would like your MC file. I did mine in Mastercam X the first of the Xseries. With an STL there is nothing I can do with that unless I was 3d prining it.You have the most of what you want done now you want a little blending at the neck to pin right?
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Correct, here is the file. Thank you.
Thanks will review today for you.I need to now take care of a few customers.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Thank you very much.