[Mark McDade]

Hi, forhire - I tried to reply to you and got the following:

"forhire has exceeded their stored private messages quota and cannot accept further messages until they clear some space."

Thanks,

Mark

[forhire]

Hi, forhire - I tried to reply to you and got the following: "forhire has exceeded their stored private messages quota and cannot accept further messages until they clear some space."

CNCZone has a very small inbox allocation. I sent you a PM with the URL for the software and manual.

[arsenix]

The DX32 control has some parameters for the probe behavior. "Post Hit Continuation" and "Back Off Distance" which you might need to tune for your probe. I haven't fooled with these yet since I haven't bought a probe yet

[Mark McDade]

The DX32 control has some parameters for the probe behavior. "Post Hit Continuation" and "Back Off Distance" which you might need to tune for your probe. I haven't fooled with these yet since I haven't bought a probe yet

There are three, 014, 015 and 016. I have played around with 15 and 16 and they don't seem to do anything (14 is probing speed and I didn't change it). I'm still puzzled that there doesn't seem to be a parameter or input field that allows compensation for probe diameter...