586,065 active members*
4,879 visitors online*
Register for free
Login

Thread: DM542A stepper driver

Results 1 to 6 of 6

Threaded View

  1. 01-23-2015, 05:59 PM #1
    poorman56
    poorman56 is offline Registered
    Join Date
    Mar 2014
    Posts
    23

    DM542A stepper driver

    I just got my cnc kit and hooked them all up for a test run and there is one that has a blinking green light. I switched the motors around and still the same thing.
    any ideas on whats wrong?
    Attached Thumbnails Attached Thumbnails DSCN0857.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. CNC setup confusion on X2 minimill, DM542A drivers, DB25-1205 BOB, & mach3
    By Cret in forum Benchtop Machines
    Replies: 25
    Last Post: 02-18-2017, 01:02 AM
  2. Replacing Syil Stepper Driver With Other driver. No Luck getting motion
    By prcdslnc13 in forum Syil Products
    Replies: 7
    Last Post: 01-10-2015, 05:49 PM
  3. Wich kit should i choose? DM542A or TB6560
    By crimar in forum Stepper Motors / Drives
    Replies: 12
    Last Post: 12-21-2013, 03:21 PM
  4. 6 leads stepper motor connect to TB6560AHQ stepper driver board
    By wf1318 in forum Stepper Motors / Drives
    Replies: 2
    Last Post: 07-25-2010, 08:19 AM
  5. STEPPER DRIVER FAQ {Stepper/driver amp per phase match.
    By huios in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 08-27-2006, 02:43 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules