[MazakAJVUser]

Welcome,



I'm trying to start milling machine AJV18 with Mazatrol M32b control, which has battery failure.


I was able to programme parameters of A,B,C,D,E,F,G,H,I,J,K,L,M,N.Q,R,S groups, but I still have problem with some points, which are:




1) In documentation there is a table called "parameters option" - I don't know where those data should be used.
It is shown on photo - it's the table in the lower right corner.

Attachment 267550


2) In documentation there is also "PLC parameter setting list" which has parameters R2100-R2109,R2110-R2537 (shown on first picture). I know how to get from the option shown on pictures
but I don't know what to do, to edit those parameters.


Attachment 267556






I can't move on if I don't know how to cope with these points. Could you help me and give me some suggestions how to do it?


With greetings

[EliseoMonteverd]

Hello, could you solve your problem? I have some information about how to change that parameters. But i would like to know if you could share your documention with me. Thank you and have a nice weekend.

[Mazaholic]

Reinitialize the control and it will load original machine parameters from eprom. The procedure is on the Mitsubishi website in the support section under "knowledge base" search for M32B and you will see it in the search results. If you haven't registered with the Mitsu site,do so,you'll need it with that control.