I have a question about hooking up the parallel connection to the Xylotex XS-3525/8S-1 controller.
There is a 9 connection plug that connects to the parallel port, I am unsure of this connection please review the below connections and let me know what is correct.
1. This is how it arrived, and how I think it is configured to the parallel connector.
VCC: RED WIRE - CONNECT ALL THREE CONTROLLERS TO VCC NO. 8 IN THE PARALLEL CONNECTOR.
STEP: WHITE WIRE – CONNECT TO 15, 5, 7 OF THE PARALLEL CONNECTOR
DIR: GREEN WIRE – CONNECT TO 2,4,6, OF THE PARALLEL CONNECTOR
ENA#:
HOME#:
MSO:
MS1:
SLEEP#:
GND: BLACK WIRE – CONNECT TO GROUND FOR ALL THREE.
2. There are five empty sockets in the 9 pin plug. What are these used for? If they are used what do they connect to?
VCC:
STEP:
DIR:
ENA#: ?
HOME#: ?
MSO: ?
MS1: ?
SLEEP#: ?
GND: