586,035 active members*
3,962 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Servo Motors / Drives > mitsubishi encoder conection

Thread: mitsubishi encoder conection

Results 1 to 2 of 2
  1. 10-17-2006, 11:15 PM #1
    rosli
    rosli is offline Registered
    Join Date
    Nov 2004
    Posts
    22

    mitsubishi encoder conection

    hi.
    i have a mitsu M-RH40AN servo drive and a mitsu HC-MF43 motor.
    reading in the manuals i dont see how to make the encoder cable for this motor beacause the motor have two pairs of signal MR,MRR and MD,MDR
    And the connector of the servodrive only have input for MR,MRR.
    The cuestion is MD,MDR are not used? if i conect only MR,MRR the driver go in A16 alarm (encoder disconected,miswired or cable short)
    any sugestion?
    Tks. Josep in Barcelona spain
    Reply With Quote Reply With Quote
  2. 10-18-2006, 12:48 AM #2
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24221
    I would guess that the MD & MDR are the common for the other two. I will look in my Mits servo manual and see if they show them.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules