[rob330t]

Hi all, I have the error code 2.1.1510 repeatedly coming up on my machine. I know its an input timeout, and the italian phrase that accompanies the code is aggregati su.
Would anyone be able to tell me where to start looking to fix this issue please?
My engineers are tied up working on another machine so I'm on my own on this one for the time being.

Thanks in advance.

[Kosmas]

Hi Rob
I cant help you with 2.1.1510, but in my notebook of damages i have 2.1.1511 wich appeared during RESET. It may be similar or even a tool close to this.
Tool 23 on my machine is cutting disk on X axis.
During "reset" the T23 didnt came up in 7 sec because the electrovalve (pneumax on me) needed to get out and to be clean with oil (attention not petroleum).
Check the other tools if going down and coming up in 7 sec during reset.
Hope to help.

[rob330t]

Hey dude,
Thanks for the reply. I'd already solved the issue. It was the sensor on the top of the routing head cylinder telling the machine that the tool was raised.
Thanks again for replying though, much appreciated.