I have a tsugami S16d with a fanuc Ot controller. Is the reset button suppose to stop everything? It does on all the other machines that Ive used before. Currently it does not. The only way to stop a command in MDI is to manually turn it off (read M3 command and then have to use M5 to stop it) or hit the Estop. That makes me a bit nervous. Ive played with parameter 45.1 (I think it was that one, it dealt with the reset button being a clear or reset function) and didn't help. It will hold with the auto stop button but the spindle stays running. I just like the simplicity of the reset being a soft Estop. Just was wondering if it was a parameter I over looked or if it was just this way with these.