[metalmansteve]

I have KIA SKT 15 LMS with a Fanuc oi-TB controller.

Seems like I need to send the turret to ref. pos. G30 U0 W0 to rotate the turret to call up a new offset.

I have up to three tools on one turret position, bringing the turret back to this position to call up a new offset slows things down....a lot!

Is there a parameter I can change that'll allowed me to do a turret rotation without going back to this ref. pos.?

Thanks!

Steve

[xavierdemoura]

Steve,

Try change D7#5 on the PMCDGN screen !!!

PWE to 1 -> SYSTEM -> PMC -> PMCDGN -> STATUS
D7 and press NO SRCH
In bit 5 change to 1

Daniel

P.S. Be carefull, because, at these point, it's possible turn the turret at any point

[metalmansteve]

Thank you!

[metalmansteve]

It now lets me do a turret change in jog mode when it's not at it's ref. pos., but it wont let me change it durring a program.....any ideas?

Steve,

Try change D7#5 on the PMCDGN screen !!!

PWE to 1 -> SYSTEM -> PMC -> PMCDGN -> STATUS
D7 and press NO SRCH
In bit 5 change to 1

Daniel

P.S. Be carefull, because, at these point, it's possible turn the turret at any point

[xavierdemoura]

Call KIA. 0012014892887 R310 Mr. Sam Caudill

He will help you

Daniel