I just recently got back involded in my CNC table project after 3 years of letting it sit idle. I've gotten it to cut but my torch keeps lifting very high off the table. My voltage readout was 0 so i started looking at the wiring to the Plasma that I installed several years ago. I noticed that one of the voltage wires that connected to the DTHC card from CandCNC had came disconnected so I reconnected in and thought OK Problem Solved. But I wasn't solved I am now getting a Voltage readout of 1 or 2 Volts. So I removed the cover from the Hypertherm 1250 to take a look at the J15 and J16 connections and they were black with soot. Everything else on the Plasma seems to be working fine. Can someone please explain to me how to begin to diagnose and repair this problem.