Water Jet? Which Pony would you bet on?
Not sure if this is the proper forum.. anyway.. We've started to look at getting a water jet here at work. We've got a rough quote from one supplier but we're looking for user feed-back. Anyone on here want to offer their experiance [good and/or bad] w/ Water Jet suppliers, make's, model's, Software? Any "got-ya's" to look at or watch for when looking at these unit's?
I've looked at Flow's website and they look like they have a decent product but.. who's to know when just looking at a website.
We're looking to primarily do stainless from the gauge level's right up through 3". Most likely a 5x10 table, we'd be looking for a complete package including auto nesting software and machine control.
As always.. opinons and experiances welcome!
Jerry
JerryFlyGuy
The more I know... the more I realize I don't
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)