Hello everyone.
I have managed to assemble this components
1 Arduino Mega 2560
1 RAMPS 1.4
3 Stepper driver Pololu A4988
1 Step Motor Nema 17
1 ATX Power Supply
But I can't make the motor move.
So far, I could just load a GRBL responding to gcodes with "ok", so I'm guessing this firmware is working correctly: https://github.com/LETARTARE/Grbl-xx...Grbl9fMega2560
The program I'm using to send the gcodes is Universal G-Code Sender.
But, I cannot figure it out how to make the motor move. I have tried Marlin and Sprinter, but both gives errors at compile time.
I've also tried using the Marlin pin setup in the GRBL which loads into the arduino mega, as I confused on which configuration should it be as PINs. I readed out there are soft pins and hardware pins, but I'm really confused.
Does anyone knows what could I do? I'm a bit frustrated.
Attachment 275262