Occasionally, I must drill several hundred small holes, depth about 12 x diameter, in a phenolic board. I use carbide circuit board drills which are limited to about .3" depth. So, for these deeper holes, I run through the pattern as far as I can go (depth) with a stock drill, then run the program again to finished depth with a new drill I have ground back the shank on (The first drill is dull and ready for the trash by the time it has done its part.).
My question is, isn't there a canned cycle or other method of writing the code to rapid the second drill down to just short of the previous depth, then begin pecking, rather than pecking the entire way down through where the first drill has already been?
Thanks for any insight!
Mark