OK, I finally got the phase converter running. Had the 110v leads hooked up to the wrong wires. I'm currently reading the following voltages:
Lead 111 to 112 = 241 volts
Lead 112 to 113 = 211 volts
Lead 111 to 113 = 224 volts

My CNC calls for 230 volts, so how do I balance these out so the CNC works properly???

I had to connect the 110volt leads to 111 and 112 wires. Now that the phase converter is putting out the higher voltages do I then come off these three leads #'s 111,112 & 113 to feed the machine? I know this sounds dumb, but I had to ask. Do I use caps to adjust the voltages so they are all the same and I've read somewhere about one of the legs being like nutural(for lack of the proper word) and how do I know which one that is? Are there any special ways the three leads get attached to the machine?

I know these all sound dumb, but I have no expereince in phase converters or using three phase.

ben