I am a super-newbie at CNC. I turned on the power of my G540 and the light was green and my estop was pushed in. When I turned the estop to pop it out, the red fault light comes on. I push it back in, it turns green again. I have no steppers connected, the printer cable is plugged in, and Mach3 is open. I don't have pins 10 and 12 jumped because I was told that if your estop is hooked up you don't do that. I'm not very knowledgeable of wiring so if someone has any insight to this it would be greatly appreciated. Thank you in advance.
Adam