[P dogg]

Hi, I would like to see if anyone might have an electrical schematic for a Multcam Turbovac TV 200, this is the 10hp 200cfm pump for the 4'x8' table size (2003 era M series). I have a problem somewhere with the line in from the on off switch at the table, switch is good, checked all fuses and voltages, motor runs when I push the contact switch in but no response when the switch at the table is on, checked for shorts in the line, any ideas or help would be appreciated.

[MCPservice]

Hope this helps

[P dogg]

Thought I should update this thread and let you know that I was able to fix the problem by tracking it down to a bad transformer, cost about $150, thanks for your help!