Hi to all,
I am new in cnc , and sorrs for my ba English i am from Belgium
I am owner of the Richauto A11 DSP handheld and i am using Visualmill from Mecsoft to generate the G-Code , now my problem ?!
How can I start the g-code may be for 50 Pieces automatic from the dsp , the manually way i did in the moment is to load every time the file from the usb stick manually into the dsp an than start the file
What needs to be done:
1- Start the file and run the g-code
2- the new piece had to be replaced to the Worktable
3- the Ok Button startet the Same file again
Is this possible an how it gets to be done ???!!!
What is to do :
-customize the Postprozessor ?
-detailed setting in the dsp ?
Who can help, please
Has anybody here in this forum a very detailed manual of the Richauto A11 DSP controler with every possible commands detailed explained, ( specially the Menue "advanced processing " ) the user manual that is shown by the machine is not so good in my opinion:
maybe anyone can send me a Link to "DSP Richauto A11 user forum"
maybe anyone can send me a Link to "Visualmill Mecsoft user forum" I know the forum of Mecsoft
maybe anyone can send me a Link to "DSP RZNC 0510 user forum"
sorry for my bad english
best regards
nostradamus100