[leprovostgildas]

Hello,
newbye into the cnc word, I want to know if anyone got the soft (DOS ? ) PROJ323
for Masterwood Project 323 of 1993 ?
My motherboard (80286) don't start anymore ?
Has anyone schematic of CN6 PC ?
I have the electrical and mechanical diagrams but not PC diagrams
Thank You
GLP.

[leprovostgildas]

Hello,
I answer myself !
I repair my machine , a small part who was bad
so it works since 5 years ago
i use the old interface under Dos ... not very easy
so i had an offer the find new control card to put into my rack of the controller CN6
A kit mounted on a Masterwood Project 309 retrofit
i bought it a piece of euros for PC under XP, rack Tecnos io cards, Z80 controller card, 68E020 controller
so i try to transpose only the 2 new cards Z80 and 68E020
in my old rack and try to use Masterwork under XP to control the global system

I read all old parameters on my cnc (param.dat, number of io attribution, etc )
to put into config file
i recompile all of them,
reflash the controller with the good file
but it don't run

Has anybody make the transformation ?
I'll put some picture of the cards
I can always run with the old system when i put back the old cards into the rack
and when i reactivate the old 286 PC card (-:

Is there any specialist of Technos/Masterwood old system ?
Regards, GLP