Hello, I recently acquired a new mill PCNC1100-3 & SprutCam-9 and I currently have my face in front of a firehose; that's what it feels like. I believe I got a grip on things; I've only destroyed one endmill (plunge issue), screwed a twist drill bit in a block at 91 ipm (off set issue) and broke one Haimer tip (PathPilot issue). My new prime objective is to minimize beginner breakage; with that a little help is needed.

There is a lot going on in SprutCam operations and the devil is in the details and unfortunately the manual lacks details. From reading previous posts here, there is much tribal knowledge to be learned and shared. I need to learn these details and hope this is the place. I also hope the soon to be released version 10 is the hallelujah version. Version 1-5 must have been a hoot.

I had a question, but I solved it while jotting it on this message; this forum is magic man.

Actually just wanted to introduce myself.

Uman in Merritt Island, Florida, USA