586,069 active members*
3,554 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Mastercam pocket doesn't cut corners

Thread: Mastercam pocket doesn't cut corners

Results 1 to 2 of 2
  1. 07-01-2015, 08:05 PM #1
    najama2
    najama2 is offline Registered
    Join Date
    Jul 2015
    Posts
    21

    Mastercam pocket doesn't cut corners

    Sorry for double posting threads
    Reply With Quote Reply With Quote
  2. 10-23-2015, 06:59 PM #2
    CNSTEVE82
    CNSTEVE82 is offline Registered
    Join Date
    Oct 2015
    Posts
    5

    Re: Mastercam pocket doesn't cut corners

    Sounds like the "Corner smoothing radius" value may be set too high. In the toolpath paramaters page, go to roughing, and try lowering the corner rounding radius value to .001

    Good Luck!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Can I pocket a projection in Mastercam X3?
    By C and E in forum Mastercam
    Replies: 1
    Last Post: 07-23-2013, 07:01 AM
  2. Pocket problem in Mastercam X5
    By cloverfield333 in forum Mastercam
    Replies: 1
    Last Post: 12-28-2012, 12:20 PM
  3. correct corners in a pocket
    By KSPATZ in forum Rhinocam
    Replies: 0
    Last Post: 03-05-2012, 04:45 PM
  4. Multicam Router/Doesn't follow mastercam Z depths
    By jbcourt in forum Multicam Machines
    Replies: 6
    Last Post: 09-20-2011, 05:12 PM
  5. How to profile a pocket with an end mill in mastercam?
    By jamie1 in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 10-24-2010, 01:26 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules