Hey guys

Hope someone can help.

I am still searching the forum, but....

I bought a TC-10 that has been standing around two years.The IO board is missing, but it looks as if that one is sorted.

The machine is still standing on a trailer, to be offloaded, but my grimy little hands could not resist to start tinkering. What I have seen so far is some slight wiring problems on the MTB side (footswitch wiring shorting) as well as Fanuc side (ribbon cable to CRT softkeys are damaged). Those are most probably the reasons the IO is missing in the first place. I am still going to trace through all the wiring anyways.

If I do get the IO. What will the procedures be? Will the machine start up as normal, or will I have to install the software and parameters again?

I also have zero paperwork on the machine I need anything that can be given: Operators manual, electric diagrams, parameter lists, ladder diagrams, 21 TB Fanuc manuals, etc, etc.

Can anyone help?