[apsmx]

Hello,
I have a Mits DWC110 with MELDAS FCA330HW Control, i has been down for a while and batteries were dead. We replaced them and had to reload the system software.
Before loading the pitch error correction and backlash & e-pak floppy disks, we need the machine to be ready.

On the maintenance alarm screen, we have a S03 SERVO ALARM: NR 0045 V
I understand that there is a problem with the V Servoamplifier, and the manual says the thermal protection probably has been damaged. I dont have the electrical diagram of this machine. But i do have the other ones.

Do anyone know where is this ServoAmplifier located in the machine??
I can only see the X & Y Amplifier on the electrical cabinet.

Best Regards.

[apsmx]

Any help would be greatly appreciated
Thanks.

[quantummachine]

You may have found the right spots already -

X Amplifier should be the servo amplifier of X axis (the servo motor of X axis)
Y Amplifier should be the servo amplifier of Y axis (the serve motor of Y axis)

Just find out which amplifier is defect and replace it with a working one.

[apsmx]

Thank you, i have found it.
It it the rightest to the right side of the X/Y Servoamplifer.

Best regards