Hi everyone,
This year we bought an old amada pega II with fanuc 6M. After very work we can do functional. From the first tests the procedure of find origin in y, x and t was perfect, however, from the last week and this week the control have problems for find the origin Y, after several times the machine find the Y origin. (I read other similar case in this forum), but, never return to origin after finish the program (no turn the light green on). However, today, we have the same problem, and after to have in point all the origin and begin a little program, the machine stop in middle of the program an put on the display X=0 Y=0 T=0. We check the machine and no saw problems.
The light of top dead center are off, we operate manually the solenoid (because the keys jog incluiding punching don´t responded) for turn on the light. after of this, we push the jog keys and the number in Y and X change, but the table don´t move, the T = 0. We can´t do anything after of that.
Please, any suggestions are welcome.
Thanks,
Alfredo